Two Component Potting Sealing Silicone Rubber TBL-6730

  • Model: TBL-6730

PRODUCT Description

Technical Parameter

TBL-6730 is two component condensed type room temperature vulcanized curing potting sealing silicone rubber.It's transparent and non-yellowing,with low viscosity of rubber compound, good leveling performance, fast flowing, smooth surface and good deep curing.The ethanol molecules are released during curing, which will not cause corrosion to copper wire and other materials.After curing, it has excellent alternating resistance to cold and heat, outdoor aging resistance, and good adhesion to most electronic accessory materials.

Product Features

Good fluidity, easy potting

Good adhesion

100% curing, no curing by-product

Operating temperature -50 ° C ~ 200 ° C

Typical Applications

Rigid Strip Lights

LED Display

Notice

The sealant will be slight yellowing during storage, which will not affect product properties.

Operating Instructions

Clean surface: Please clean up the dust, rust, and oil on the surface of the bonding substrate.

Gluing: Squeeze the sealant onto the cleaned surface.               

Curing: Place the glued part in the air, after skin formation, cure continues inward from the surface.Under 25℃ and 55% relative humidity conditions for curing 24 hours, the sealant will cure to a depth of 2 to 4mm, with time prolonged, the curing depth gradually increased.

Storage:  The unused sealant should be immediately tightened and sealed. Before using again, remove the crust at the nozzle mouth and do not affect normal use.In the process of storage, the sealant may be a small amount of solidification at the nozzle, which can be used normally after removal without affecting the product properties.  

Storage conditions

Store in a cool and dry place below 35 ℃.

Shelf life: 6 months.

Attention

1. Keep away from children.

2. It is recommended to use it in a well-ventilated area to reduce odor.

3. If accidentally touch the skin or eyes, wipe them clean immediately, then rinse with water and seek medical advice.

4. For safety information, please refer to the Material Safety Data Sheet (MSDS).

Packaging specifications

100ml / piece, 100 pieces / Carton.

300ml / piece, 24 pieces / Carton.

2600ml / piece, 4 pieces / Carton.

Special Note

The data in this manual were obtained under laboratory conditions, due to differences in the use environment, users should refer to these data and conditions for analysis and testing. Tian Bao Li does not guarantee the sales of products and the use of Trimble products under specific operating conditions, and does not assume any liability for direct, indirect or accidental losses. If the user encounters any problems during use, you can contact the Tian Bao Li technical service department, we will provide you with the help. 

Function Model TBL-6730 Standard Test
Uncured Function
Colour Transparent Visual
Viscosity /mPa·s 800~2000 ASTM D1084
Operating Function
Operating Time /min 30~60 ——
Curing Time /h@25℃ 24 ——
After Curing Function
Hardness/ Shore A 15~25 ASTM D2240
Dielectric Strength /kV/mm >18 ASTM D149
Volume Resistivity /Ω·cm >10⁴ ASTM D257

INQUIRY

CONTACT US

contact-email
contact-logo

Foshan Tian Bao Li Silicon Engineering Technology Co., Ltd.

We are always providing our customers with reliable products and considerate services.

If you would like to keep touch with us directly, please go to contact us

  • Home

    Home

  • Tel

    Tel

  • Email

    Email

  • Share

  • Contact

    Contact